ANGUS RDA by NEVOKS is made of zinc and plastic. Sold in four colors: Black, SS, Rainbow, Gradient. The board receives 3 power modes and it gives out up to 60 watts. The cartridge is designed for self-service. It supports working with a grid or ordinary wire.
Dimensions
Height: 80 mm,
Width: 39 mm,
Thickness: 18.4 mm.
Technical specifications
Output power: from 5 to 60 watts,
Coil resistance: 0.18 and 0.5 Ohms,
Battery capacity: 1700 mAh.
Cartridge Overview
The drip tip is combined with the cartridge skirt. It is made of black translucent plastic. On both sides are holes for air intake.
The kit comes with an additional dome with slightly smaller holes. Airflow adjustment is not provided.
The base with two terminals will allow you to install the coils from the network or wire.
The central unit is made of ceramic and equips with a spring for better contact between the wick and the network.
On the sides are small baths for laying cotton wool.
To remove the cartridge from the battery pack, you must move the tank to the side. It is held in special grooves.
Battery pack, pod control
The case has a glossy finish. On the side, there is a button for work. On the front side, there are three LED indicators. They are responsible for indicating the selected power mode. To change them, you need to click on Fire Button three times.
The exact power values for each mode are not indicated by the manufacturer. Apparently, they will depend on the resistance of the coil. The board supports resistances from 0.18 ohms. Output power ranges from 5 to 60 watts. The built-in battery received a capacity of 1700 mAh.
One vaper recall
On a complete grid with minimal power for operation, The device resembles the use of a conventional grid drip. The puff was loose on both domes; there was no significant difference between them. For refueling, it is better to use ordinary liquids on alkaline nicotine, as for serviced atomizers.
To wind a cartridge is quite convenient. In the kit there is no frame for the mesh, so you have to use improvised tools. The bathtubs are not very large, so it is recommended to use the maximum amount of cotton wool to increase the volume.
The size of the hole of the drip tip will allow you to fill through it. The main thing to remember is that the air intake holes are quite low, otherwise you can fill in the mod. Additionally, due to such a construct, it is not very convenient to carry the device if it has a little liquid.
When tilted, it may leak out through the holes. I liked the type of cartridge mounting in the form of a slider. But with the implementation, it didn’t work out very well, due to poor attachment, the tank is removed without effort.
The body of the mod is glossy, so it will quickly scratch and collect any dirt. The button has a nice click. There are no complaints on the board, it works quickly. When using complete mesh coils performance is also good.
The battery has a capacity of 1700 mAh. Therefore, with active use, it may last 6-8 hours. As a result, we get a board with a “drip” in the hearth format with free traction. The implementation is interesting, albeit not without features. Therefore, this kit is suitable for fans of mesh drips and free traction.
